Renjit

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Plaster Orgonite #932

    by renjit8650 » Sat Oct 22, 2011 7:00 pm
    Dear Josh,
    Before purchasing the cable for broadcasting , I request you to clarify the following in order to select the cable
    for coiling around the cone.
    I have 2 options, connect the coil to a) fridge or b) computer.
    As you know, computer requires very less power and therefore 1.5 mm2 cable is okay and fridge requires 4 mm2 cable. Here if the energy increases with increase of amps
    as in the case of fridge, I will connect it to the fridge or else I will settle with computer power cable, which is very much easy for me.
    Kindly advise. Thanks
    Renjit

    in reply to: Plaster Orgonite #931

    Thank you very much Josh for your prompt advise.
    Plasterite pyramid 8 inch size made with 5 no: locally purchased quartz crystals. Cracks already visible on the bottom dry surface.

    Plasterite cone of 30 inch height, made with sea shells as substitute for quartz crystals. Energy can be sensed in the room.

    Even though the total height of the traffic cone is 38 inches, I filled only up to 30 inches fearing that plasterite may not come out of the mold.
    Now if the POR output remains same with orgonite inside the traffic cone permanently, I can fill the traffic cone to 38 inch height and leave
    orgonite inside the mold as it is.

    This will be a protection to the orgonite inside while broadcasting also. And for the next, traffic cones can be purchased again. Considering the saving between plasterite and orgonite resin, purchase of traffic cone is not an issue. Kindly advise.

    I would like to post both the pictures to get bovis reading.

    Thanks

    Renjit

    in reply to: Plaster Orgonite #930

    After getting a mold pyramid 8 inch size and a traffic cone of 40 inch height, with other materials except for the quarts crystals which was ordered by Oct 11, 2011. It seems the delivery of crystals are delayed. I lost my patience as well.

    My plan is to make plasterite, 1 pyramid for my living room and one cone- for broadcasting. If beach sand and sea shells can replace crystals without much reduction in the POR conversion, I can start right now. kindly advise.

    Thanks

    Renjit

Viewing 3 posts - 1 through 3 (of 3 total)